Reader and Connection Problems
What to do when the reader won't scan or the device is offline.
These messages and behaviours can show on any scanning page in the Ramp app. Find the one you see below to see what it means and what to do.
For how the trigger and the RFID Reading chip work, see How to Scan with the Handheld.
Reader and Connection Messages
| Message | What it means | What to do |
|---|---|---|
| Reader disconnected (on a scanning page) | No reader is connected. | Turn the reader on and wait a few seconds; it reconnects by itself. If it doesn't, ask your administrator. |
| Device not licensed | This device isn't licensed to scan. | Check the licence. See How to Check the Device Licence. |
| Couldn't start scanning. Check the reader and try again. | The reader didn't start. | Check that the reader is on and charged, then pull the trigger again. |
| Offline: scans are kept on this device | The device has no connection. | Keep scanning; save when you are back online. |
| The page starts reading by itself | The reader is set to start reading when a scanning page opens. | Click the trigger to stop if you aren't ready. |
| Save or Finish is greyed out while scanning | The reader is set so that you must stop reading before saving. | Click the trigger to stop reading; the buttons become available. |